The default values set by the installer during installation are restored by using the Page Menu options. The “Restore Unit Defaults” selection restores all default settings. Pressing the DFLT UNIT soft key will also restore the Default Unit settings. The “Restore Airspeed Defaults” menu selection or soft key restores only the Airspeed Reference default settings. The RA TEST soft key activates the Radar Altimeter test mode. See the Radio Altimeter section in Section 2 for details.

NOTE: Not all Radar Altimeters have the TEST function.

1) While viewing the Aux mode System Setup page, press the MENU key.

Figure 3-67 Aux Mode System Setup Page Menu

2)Turn the large or small MFD knobs to highlight the desired selection and then press ENT.

3.4.1.1Display Brightness

Display brightness mode may be set to manual or automatic. The automatic mode will set the display brightness based on the ambient light. The manual mode allows the setting of display brightness between 0 and 100%.

1)Turn the large MFD knob to reach the AUX page group. Press the small MFD knob to activate the cursor.

2)The Level will be highlighted. Turn the small MFD knob to select the Display Brightness Level and then press ENT.

Figure 3-68 Aux Mode Display Brightness Level Selection

3)If the Level was changed, Manual will be selected. Press the cursor to save the settings. If you press ENT the Mode setting will be highlighted.

Foreword

 

 

System

Sec 1

 

PFD

Sec 2

 

Sec 3 MFD

 

Avoidance

Hazard

Sec 4

Features

Additional

Sec 5

& Alerts

Annun.

Sec 6

Symbols

Sec 7

 

Glossary

Sec 8

 

Appendix A

 

 

Index

Appendix

 

 

B

 

190-00601-02 Rev. E

Garmin G600 Pilot’s Guide

3-51

Page 121
Image 121
Garmin G600 manual Display Brightness, Aux Mode System Setup Page Menu