Garmin G600 manual Cell Movement Data Viewing Range, Cell Movement Viewing Range Selection

Cell Movement Data Viewing Range

The Cell Movement Data Viewing Range option allows you to select the map range and below where Cell Movement weather products will appear on the selected MFD Wx Data Link Map page (1, 2, or 3). When Off is selected, Cell Movement will not be shown. In the figure below where 300 NM is selected, Cell Movement data will be shown at map ranges of 300 NM and lower.

Figure 4-47 Cell Movement Viewing Range Selection

1)While viewing a WX Data Link Map page of the WX page group, press the MENU key to display the Page Menu Options. The cursor flashes on the “Weather Setup” option. Press ENT.

2)Turn the large MFD knob to highlight the Cell Movement Data Viewing Range value.

3)Turn the small MFD knob to highlight the desired value. Press ENT to accept the displayed value. The next option will be highlighted.

4)Press the small MFD knob to cancel selection or to end editing and return to the Navigation Map page or turn the large MFD knob to the next option.

Foreword
System	Sec 1
PFD	Sec 2
Sec 3 MFD
Sec 4 Hazard Avoidance
Features	Additional	Sec 5
& Alerts	Annun.	Sec 6
Symbols	Sec 7
Glossary	Sec 8
Appendix A
Index	Appendix
	B

190-00601-02 Rev. E Garmin G600 Pilot’s Guide 4-65