Garmin G600 manual Range Ring, Switching from Standby Mode to Operating Modes

Operating
Mode	Range Ring Diameter
Ownship	Traffic Advisory,
	Aircraft is 1200 ft
Symbol	Above and Climbing
Non-Threat
Traffic	Proximity Advisory,
	1200 ft Above and
	Climbing
	Traffic Advisory,
	Off Scale Aircraft
	is Out of Range,
	1200 ft Above and
	Climbing

Non-Bearing Traffic (System is Unable to

Determine Bearing), Aircraft Distance is

8.0NM, 1100 ft Above and Descending

Figure 4-28 Traffic Map Page - TAS

4.7.1.1Switching from Standby Mode to Operating Modes

The unit must be in operating mode for traffic to be displayed. The ability to switch from standby to operating mode on the ground is especially useful for scanning the airspace around the airport before takeoff.

1)While viewing the Traffic Page of the MAP page group, select the OPERATE soft key to select Operating Mode.

2)To switch to Standby Mode from the Traffic Page, select the STANDBY soft key.

NOTE: Not all TAS systems can be controlled from the G600. The Operate/ Standby soft keys may not be displayed. An alert will be generated when Standby is selected and the aircraft is in the air.

4.7.1.2Range Ring

Pressing the RNG keys will zoom in and out in preset steps depending on the installed equipment.

Foreword
System	Sec 1
PFD	Sec 2
Sec 3 MFD
Sec 4 Hazard Avoidance
Features	Additional	Sec 5
& Alerts	Annun.	Sec 6
Symbols	Sec 7
Glossary	Sec 8
Appendix A
Index	Appendix
	B

190-00601-02 Rev. E Garmin G600 Pilot’s Guide 4-33