Garmin G600 manual Changing CDI Course, New Course Setting

1)Press the CDI soft key to toggle between GPS and VOR/LOC source type.

2)Press 1-2soft key to toggle between the 1 and 2 navigators of the GPS or VOR/ LOC sources.

3)Verify the navigation source by the indication on the HSI and in the upper left corner of the PFD.

NOTE: The selected navigator is the active navigator for all PFD and MFD operations, except for the supplemental bearing pointers.

2.7.2Changing CDI Course

The Selected Course is shown to the upper left of the HSI for 10 seconds after being adjusted.

New Course Setting

Figure 2-30 Course Setting

1)Press the CRS key to activate Course mode.

2)Turn the PFD knob to change the Course values.

OR

3)Press the PFD knob to set a Course that will center the CDI to the VOR station or waypoint if in GPS OBS mode.

Foreword
System	Sec 1
PFD	Sec 2
Sec 3 MFD
Avoidance	Hazard	Sec 4
Features	Additional	Sec 5
& Alerts	Annun.	Sec 6
Symbols	Sec 7
Glossary	Sec 8
Appendix A
Index	Appendix
	B

190-00601-02 Rev. E Garmin G600 Pilot’s Guide 2-23