Pelco FX82012 manual Installation, Package Contents

Installation

PACKAGE CONTENTS

The following items are supplied:

1FX82012 module

1Regulated switching power supply with four plug adapters (North American, Australian, U.K., and European configurations); 100-240 VAC, 50-60 Hz input, 12 VDC output

1Wall clip with two 4-40 x 0.250-inch Phillips pan head screws with lock washers (for attachment of single module to wall)

1FX82012 Unmanaged Ethernet Switch Installation manual (this manual)

SETTING 10BASE-T/100BASE-TX PORT MODES OF OPERATION

NOTE: As a matter of convenience, it is recommended that you verify the modes of operation for the 10BASE-T/100BASE-TX port and then change the mode settings—if necessary—before mounting the FX82012 module into a rack or onto a wall.

The FX82012 module provides various configuration options that allow you to select the desired modes of operation for the 10BASE-T/100BASE-TX port. You can select the desired modes of operation by means of a TX Mode switch that is provided on the bottom of the module (refer to Figure 5).

TX Mode

0.Auto Neg / Dis FC

1.100 FD / Dis FC

2. 100 HD / Dis FC

3.10 FD / Dis FC

4.10 HD / Dis FC

5.Auto Neg / En FC

6.100 FD / En FC

7.100 HD / En FC

8.10 FD / En FC

9.10 HD / En FC

FX Mode

0. Independent A & B

1. Auto Failover

A is Primary

2. Auto Failover

B is Primary

3-9 NOT USED

TX MODE SWITCH

Figure 5. TX Mode Switch for 10BASE-T/100BASE-TX Port

12 C2624M (6/07)