C2694M (7/08) 17
Connections
Familiarize yourself with the GW5000 rear panel before connecting any equipment to the unit.
Figure 13. Rear Panel Layout

CONNECTING POWER

The GW5000 uses an autoranging power supply that automatically adapts to voltages between 100 VAC and 240 VAC (50/60 Hz).
Connect one of the supplied US, European, or UK standard power cords to the rear of the unit, and then connect each c ord to the appropriate
power source:
1. Connect one power cord to the back of the GW5000.
2. Connect the other end of this power cord to the appropriate power source.
NOTE: Do not turn on the GW5000 until you have connected all components.

CONNECTING TO THE NETWORK

The GW5000 is compatible with the entire family of Endura-ready devices using TCP/IP and UPnP protocols. Consult your net work administrator
before installing the GW5000 to avoid possible network conflicts.
The GW5000 has two network connectors on the rear panel: one for connecting to the Endura (private) network and the other for c onnecting to a
public network, such as the Internet.
To connect the GW5000 to the private Endura network:
1. Connect a Cat5e (or better) cable to the private network connector near the center of the GW5000 rear panel.
2. Connect the other end of the network cable to a 100Base-T (or better) port on the Endura network switch.
To connect the GW5000 to the public network:
1. Connect a Cat5e (or better) cable to the public network connector towards the right side of the rear panel.
2. Connect the other end of the network cable to the public network.
ìPower Switch
îPower Connector
ïNot Used
ñNetwork Connector (private)
óNetwork Connector (public)
FREQ: 50/60 Hz
AMPS: 0.7
VOLTS: 100-240 ~
MADE IN USA
SN: