Pelco GW5000 Before You Begin

C2694M (7/08) 9

Before You Begin

Endura is a network system that requires a continuous amount of bandwidth to transmit true, live video. Therefore, always include your network

administrator when planning and installing Endura components.

You will also need the following items:

• Pelco-approved Endura certification

• Access to an Endura network

– that is an active, Gigabit Ethernet network that supports the ful l Internet Protocol IP suite,

– that is configured with at least one NVR5100 Series network video recorder or other Endura video recorder, and

– that is configured with at least one Endura workstation or other PC running WS5000 advanced system software, and

– that is configured with at least one SM5000 system manager.

NOTES:

• Endura components are designed to deliver high quality, high frame rate video across a network. For best results, make sure your

installation meets the power, environmental, and networking guidelines described in the Endura Installation Guidelines and Best Practices

document (C2670M).

• When using one or more network switches on the Endura network, enable autonegotiation on all switches.

• These network requirements represent the minimum standard for a small Endura-capable security network. Please consult the Endura

Network Design Guide (C1640M) to make sure your network is properly configured. Your system may be different and may require

additional hardware, software, and network resources.

1 GW5000 gateway

1 Accessory pack:

4 Rubber feet with 8-32 x 0.25-inch, Phillips pan head screws (for desktop mounting)

3 Power cords (1 USA standard, 1 European standard, and 1 UK standard)

2Front bezel keys

1 Rack mount kit (included with accessory pack):

2 Chassis mounting brackets with thumbscrews

6 Screws, 6-32 x 0.25-inch, Phillips flat head (three for each bracket)

2 Adjustable support rail sets (each set includes 1 front-mounting rail and 1 rear-mounting rail)

6 Screws, 8-32 x 0.375-inch, Phillips truss head (3 for each support rail)

4 Screws, 10-32 x 0.5-inch, Phillips flat head (3 for each front rail)

4 Screws, 10-32 x 0.5-inch, Phillips pan head (3 for each rear rail)

10 Cage nuts, 10-32

3 Product serial number labels (attached to unit )

1 GW5000 Installation manual (C2694M)

1 Endura Important Safety Instructions (C604M)

In addition to the standard tools and cables required for a video security installation, you will need to provide the following items:

1 Cat5e (or better) cable and connectors for connecting the GW5000 to the Endura network

2 Screwdrivers, 1 Phillips head, 1 flat head, for mounting the unit in a rack or attaching accessories to the GW5000

You also need to provide all network equipment, such as switches, for the Endura network.