INSTALL BASE
WITHOUT CONDUIT
1.Pull the power and video wiring for the camera through the mounting surface and then through the wiring hole in the mounting plate. Fasten the mounting plate to the mounting surface with #8 stainless steel screws (not provided) of the appropriate length.
Adjustable mounting pattern only: Adjust the angle of the base before tightening the mounting hardware.
2.Connect the power input wires to the power wires located on the bottom of the ICS210 base. Refer to the following to connect the power wires:
24 VAC:
Connect power to the red and blue wires. The black wire is not used.
12 VDC:
a.Connect +12 VDC to the red wire and ground to the black wire. The blue wire is not used.
b.Reset the voltage jumper located on the camera power board inside the base of the Camclosure (Refer to Figure 5). Remove the jumper from AC position and reinstall the jumper on the DC position.
24 VAC
12 VDC
Figure 5. Voltage Jumper Settings
3.Connect the video cable. Make sure the boot covers the BNC connectors.
4.Push the power wires and video cable back through the mounting surface. Line up the mounting holes in the base with the mounting holes of the mounting plate. Attach the base to the mounting plate with the three
WITH CONDUIT
1.Prepare the conduit for the installation.
2.Fasten the mounting plate to the mounting surface with #8 stainless steel screws (not provided) of the appropriate length.
Adjustable mounting pattern only: Adjust the angle of the base before tightening the mounting hardware.
7 |
