Pella 818K0100 installation instructions YOU will Need to Supply Tools Required

The performance of any building is dependent upon the design, installation, and workmanship of the entire building system. Pella Corporation strongly recommends consulting an experienced architect, contractor, or structural engineer prior to installation of Pella products.

The individual (building owner, architect, contractor, installer and/or consumer) responsible for the project must take into account local conditions, building codes, inherent component limitations, the effects of aging and weathering on building components, and other design issues relevant to each project.

The determination of the suitability of all building components for each project, as well as the design and installation of flashing and sealing systems, are the responsibility of the building owner, architect, contractor, installer and/or consumer.

YOU WILL NEED TO SUPPLY:	TOOLS REQUIRED:
• Cedar or Impervious shims/spacers (12 to 20)	• Tape measure
• 16d galvanized finish nails (1/4 lb.)	• Level
• #10 x 3-1/4" corrosion resistant wood screws
(Performance Upgrade and HurricaneShield)	• Square
• Masonry screws for concrete applications

(Minimum of 3/16" diameter x 3")

•Closed cell foam backer rod/sealant backer (21 to 30 ft.)

•Pella® SmartFlash™ foil backed butyl window and door flashing tape or equivalent

•High quality exterior grade polyurethane or silicone sealant (2 to 3 tubes per door) SEALANT

•Great Stuff ™ Window and Door Insulating Foam Sealant by the Dow Chemical Company or equivalent low pressure polyurethane window and door foam - DO NOT use high pressure or latex foams

•Sill Pan (Optional)

6-5/8" x (Rough Opening Width + 2")

•Pella aluminum sill support or wood blocking

•Interior trim and/or jamb extensions (15 to 40 ft.)

•Aluminum Head Flashing

INSTALLATION CLIP OPTION:

•6" or 8" installation clips

•#6 x 5/8" corrosion resistant flat head wood screws

• Hammer

• Stapler

• Sealant gun

• Scissors or utility knife

• Tin snips

•Screwdrivers (#2 Phillips with 8" shaft and small flat blade)

• T20 Torx Wrench

• Drill

•Drill bits 13/64" and 1/8" and masonry bit for concrete applications

• #8 x 1-1/2" corrosion resistant screws or 3/16" x 1-1/2" masonry screw