of sealant into the three sill strike holes and install the three # 8 x 3" flat head stainless steel screws (provided) into the holes.
K.Shim between the frame and the rough opening at the head strike location and
D O O R S • A L L D O O R S • A L L D O O R S • A L L D O O R S
at every frame anchor hole location. Remove and replace head strike screws with three #8 x 3" corrosion resistant screws (provided) through the head strike, door frame, shims and into the rough opening.
Note: For doors with no head strike check head for
L.On each hinge, starting at the top, insert a corrosion resistant screw (#12 x
into the open screw hole. Make sure the screw passes through the shims and into the structural framing.
Interior
3K
3J
Interior
3L
• A L L D O O R S • A L L D O O R S • A L L
M. Check door operation. Open and close |
|
the door to check for proper operation. |
|
Make sure the door will latch correctly. |
|
Note: If there are any problems with |
|
the operation, check to confirm the |
|
door frame is installed plumb, level |
|
and square. If the reveal between the |
|
door panel(s) and frame is not even, |
|
adjustments may be made: |
|
Doors WITHOUT adjustable hinges: |
|
Plastic shims located behind the hinges |
|
may be removed to adjust the reveal |
|
between the door panel and door frame. |
|
Additional hinge shims may be added | Adjustable |
if required. | Hinge |
Non-Adjustable
Hinge
D O O R S
Note: Doors with adjustable hinges will have a
Adjustable hinges are not designed to make up for failure to install the door frame correctly. Before adjusting hinges, confirm the door is installed plumb, level and square.
