Pella 818K0100 Integrating the Door to 4WATER Resistive Barrier, L D O O R S a L

A L L D O O R S

N.For Doors with adjustable hinges: The hinges can be used to move the panel side to side by moving all hinges in the same direction or the hinges can slightly rotate the panel by adjusting the hinges in opposite directions. Use a T20 Torx wrench to turn the center screw clockwise (+) to increase the space between the hinge side of the frame and door panel. Turn the center screws counter-clockwise (-) to decrease the space between the hinge side of the frame and the door panel .

Note: Do not adjust the hinge with the top and bottom screws loose; this could force the hinge to adjust beyond its design capability which can cause the hinge to bind, damage the hinge and/or pull out the screws. A 3/4 turn of the center screw provides approximately 5/32" adjustment.

L D O O R S • A L L D O O R S •

O.On doors with a lock strike in the side, drill a 1/8" diameter x 2" deep pilot hole into the rough opening through the two pre-drilled holes in the frame. One pre-drilled frame hole is located in the center lock strike hole and the other is the upper frame corner installation hole approximately 8" from the top of the door frame head. Insert a #8 x 3" screw (provided) into the pilot hole making sure it passes through the shim and into the rough opening framing.

Note: This step does not apply to center latching double doors.

3O	Head	3O
*	~8”
A
M
B

• A L L D O O R S • A L

INTEGRATING THE DOOR TO THE
4WATER RESISTIVE BARRIER	&YUFSJPS
A. Apply a corner bead of sealant at the point
where the brickmould or flat casing contacts
the wall along the head and jambs. Also apply
a bead of sealant at each end of the head
brickmould.	4A"

D O O R S • A L L D O O R S

B.Install the head flashing.

C.Apply a piece of flashing tape over the head flashing as shown.

D.Fold down the top flap of the water resistive barrier. Cut the water resistive barrier so it covers the vertical leg of the head flashing, however does not lap onto the horizontal leg of the head flashing.

)FBE
nBTIJOH

4B#

4FBMBOU

4D%

'MBTIJOH UBQF
)FBE nBTIJOH	4C$

D O O R S • A L L

E.Apply flashing tape to the diagonal cuts. Cut two pieces of flashing tape at least 1" longer than the diagonal cuts in the water resistive barrier. Apply the tape covering the entire diagonal cut in the water resistive barrier at both upper corners of the brickmould/flat casing.

&YUFSJPS

4E&