P E R F O R M A N C E U P G R A D E
B.Doors using Installation Clips: Install installation clips. Place each clip so the lip is facing up and against the brickmould at the locations shown in the placement diagram. Secure each clip by driving a #6
x 5/8" corrosion resistant screw through each of the outer two holes of the three holes shown.
Note: If clips are to be bent; pre- bend before attaching to frame.
#6 x 5/8” corrosion resistant screws
Lip
2B
6“ from end
D O O R S • A L L D O O R S • A L L D O O R S
3SETTING AND FASTENING THE DOOR
A. Place three 3/8" beads of sealant. Place |
|
|
|
|
|
|
the first bead of sealant 1/2" from the base |
| 1st Bead |
| 3A |
| |
of the interior sill pan lip. This bead should |
| 2nd Bead |
|
| ||
|
|
|
|
| ||
also continue up the corner of the sill pan |
| 6” |
| Leave a 2" |
| |
at each end, sealing the vertical joints of |
|
|
| break | ||
| INTERIOR |
| in center |
| ||
| SILL | of pan | ||||
|
|
|
|
| ||
|
|
|
|
|
| |
the sill pan legs. Continue the first bead |
|
| PAN |
|
| |
|
|
| LIP |
|
| |
up 6" onto each jamb side of the rough |
|
|
|
|
|
|
opening. The second bead should be | 3rd | Bead |
|
|
|
|
approximately 1/2" from the exterior edge |
|
|
|
| ||
|
|
|
|
|
| |
of the rough opening, running from jamb |
|
|
|
|
|
|
to jamb with a 2" break in the middle of the |
|
|
|
|
|
|
opening. Place a third sealant bead in the |
| 6” | B |
|
|
|
groove of the sill support from end to end |
| 3A |
|
|
| |
|
|
|
|
| ||
or 1/4" from the exterior edge of the wood |
| 1 |
|
|
|
|
blocking. |
| 2 |
|
|
|
|
|
|
|
|
|
| |
|
| 3 |
|
|
|
|
Note: Sill sealant detail is the same for |
|
|
|
|
|
|
applications with and without optional sill pan. |
|
|
|
|
|
|
|
| Applications without sill pan |
|
| ||
TWO OR MORE PEOPLE WILL BE REQUIRED FOR THE FOLLOWING STEPS.
A L L D O O R S • A L L
B.Cut and remove the strap that runs from the door lock to the sill of the door.
C.Insert the door from the exterior of the building DO NOT slide the bottom of the door into the opening. Sliding will damage the sealant lines. Place the bottom of the door at the bottom of the opening with the door centered between the sides of the opening to allow for shimming, then tilt the top into position. Insert one 16d galvanized finishing nail at each upper corner of the brickmould. These are used to hold the door in place while shimming it plumb and square.
3CÓ
&YUFSJPS
