EQUIPMENT CONTROL:
The Controller houses a 24 hour Clock with a digital display, which is used to program daily filtration cycles and
auxiliary equipment (such as pumps and lights).
There are five
Equipment Buttons
which are used for switching the pool equipment ON or OFF:
FILTER Button:
Activates filter pump, and circulates water through the filtration and heating system.
Enables water to be heated.
AUX
1
Button:
Activates auxiliary 1 equipment (such as spa light or pool cleaner).
Note: If pool cleaner is used, it will be delayed for 4 minutes whenever it is activated, and
it will also automatically activate the filter pump (even if FIIXER Button is not switched ON).
See "POOL CLEANER PROTECTION" (Page
3).
AUX
2
Button:
Activates auxiliary 2 equipment (such as a fountain),
AUX
3
Button:
Optional. Activates auxiliary
3
equipment (such as jet pump or waterfall).
AUX
4
Button:
Optional. Activates auxiliary 4 equipment (such as landscape lights).
Note: The daily operation of this equipment cannot be programmed.
The
PROGRAM, HOURS
and
MINUTES Buttons
are used for setting the Clock, and for programming the daily
operation of the FILTER, AUX 1, AUX 2, and AUX
3.
See Page
6.
The
DELAY CANCEL Button
is used to override the "Pool Filter Pump Off Delay" and optional "Pool Cleaner On
Delay" circuits (for testing and servicing purposes only).
Status Lights
are provided for the various pieces of equipment controlled by the CP-1000.
The presence of a light indicates that the equipment has been activated. The absence of a light indicates that the
equipment is turned off.
'TEMPERATURE CON'TROL:
HEAT SOURCE Switch:
It is possible to heat you spa or swimming pool using solar energy, conventional heat, or a combination of both.
However, no heating will take place unless the filter pump is running:
SOLAR Position:
Allows heating with solar only.
S-PREF Position:
Allows preferential heating with solar, but automatically switches to conventional heating
when solar energy is unavailable.
HEATER Position:
Allows heating with gas or electric heater only.
Note: If you are heating a swimming pool, your Pool Builder may have modified the Controller
so that the solar system will also contribute to the conventional heat whenever solar energy is
available.
OFF Position:
Allows no heating.
SOLAR ON Light:
lndicates whenever solar system is on.
HEATER ON Light:
Indicates whenever gas or electric heater is on.
THERMOSTAT Dial:
Used to preset your desired water temperature.
As long as
HEAT SOURCE Switch
is not in the "OFF position, the water will heat up to the preset temperature
whenever the filter pump is running.
Temperature Display:
Whenever the filter pump is running, the precise water temperature will be displayed in degrees Fahrenheit.
Note: Filter pump must be running in order to provide accurate temperature display.