PROGRAMMING
It is possibleto preset six programs during a 24 hour period.
Each of the six programs can be used for turning equipment ON or OFF.
More than one piece of equipment can be turned ON or OFF at each program. However, to turn the same piece of equipment ON and OFF requires two programs. It is therefore advisable to overlap programs.
Once the programming is complete, the equipment will operate at the same times every day.
Before commencing programming, it is advisable to determine 1) what equipment you wish to control, 2) at what time you would like the equipment to turn on, and 3) for how long you would like each piece of equipment to run.
To better understandthe programming sequence, let'sfollow asample program, step by step.
In our example, the Control System is being used for a spa, and we would like to activate the following equipment: Turn AUX 2 (fountain) on from 11:OO am until 6:00 pm.
Filter (and heat) the spa from 6:00 pm until 7:00 pm. Turn AUX 3 (jet pump) on from 6:30 pm until 7:00 pm. Turn AUX 1 (spa light) on from 8:30 pm until 10:OO pm.
To begin programming, push PROGRAM BUlTON once.
"PROG 1"will appear on the right of the Display. This indicates that the Clock is in Program Mode, and that the first program is ready to be entered.
Enter the first program time (11:00 am in our example) by pushing the HOURS and MINUTES Buttons.
In Program Mode, minutes are advanced in ten minute increments.
Push AUX 2 Equipment Button.
"ON" should appear directly above AUX 2 Button.
If "ON" is displayed above any of the other Equipment Buttons, push appropriate Button once, and "OFF will appear.
You have now completed the first program.
To
"PROG 2" will now appear on the right of the Display. This indicates that the second program is ready to be entered. Enter the second programtime (6:OO pm) by pushingthe HOURS
and MINUTES Buttons.
Pay special attention to the AM/PM indicator.
In our example, we would like to turn off the fountain (AUX 2) and turn on the spa filter pump (FILTER) at 6:00 pm.
Push FILTER Equipment Button.
"ON"should appear directly above FILTER Button.
Make sure that "OFF is displayed above AUX 1, AUX 2 and AUX 3 Equipment Buttons.
Push PROGRAM Button to
