33

4 TURNING THE POWER ON
4 TURNING THE POWER ON

4-1 Turning the Power On and Off

Pressing the [POWER] key shows the initial
screen.
(The [POWER] key is also used to turn the
power off.)
After a few seconds, it turns to Electronic vial
screen. Move the vials to center by adjusting
the leveling screws.
Pressing the [ENT] key views the angle
and distance measurement screen.
●The Auto Power Off function will automatically turn the power off if no
operations are performed for approximately 10 minutes.(Factory default
setting)
●The [POWER] key is controlled by software in the instrument while it is
working, and this key is valid only when turning off causes no problem.
●The value displayed when the power was last time turned off will be displayed
for the horizontal angle.If this hor izontal angle is not needed, please perform
horizontal angle 0 SET.
For details on resetting the horizontal angle 0 ............See page 37.
For details on changing the horizontal angle from
clockwise to counterclockwise ...............................See page 41.
For details on measuring the vertical angle .................See page 40.
For details on distance measurement .........................See page 42.
For details on the automatic power-off function ..........See page 59.
For details on the Electronic vial ..................................See page 65.
ELECTRONIC VIAL
T.COMP.
ON
30"/1DIV
LD POINT
PLUM ADJ
SENS.
MEAS TARGET 0 SET DISP MODE
MODE A 15°C S 0

H. angle 40"39'85°

H. dst. 0000000°

V. dst. 000000°
h
PENTAX R-300 (p20-52) 10/30/02 11:08 AM Page 33