55
8 INITIAL SETTING
8-6 Example of Changing an Initial Setting Content(Selection of Atmospheric Correction)
This section describes the operating procedures for selecting “1.ATM CORR”in
Initial Setting 1 as an example of changing an Initial Setting content. Use this
example as a reference when changing other items because it is also applicable
to the operating procedures for changing them.
Access the screen for Initial Setting 1 by
taking procedures “Entering the Mode for
Initial Setting 1”on page 50.
Press [F5] [SELECT] to open the screen for
selecting the atmospheric correction.
Press [F3] [g] or [F4] [h] to position the
cursor at the desired item, then press [ENT]
key to select that item.
Pressing the [ENT] key settles the change of
selected item. Pressing the [ESC] key
invalidates the change of selected item.
Pressing again the [ESC] key or [ENT] key
quits the initial setting screen and usual start
screen appears.
SELECT
SET 1
1.ATM CORR : AUTO
2.
PRISM CONST
: 0mm
3.
SHEET CONST
: 0mm
4.
CRV/REF CORR
: 0.14
5.
COMP AXIS
: NIL