57
8 INITIAL SETTING
8-8 Initial Setting 2
1. Selection of Minimum Distance measurement unit :
[MEAS. MIN DISP]
COARSE or FINE:
2. Selection of the Shot count : [SHOT COUNT]
Select whether the shot count for Shot distance
measurement is to be 1,3, 5, or an arbitrary count to be
entered.
3. Setting the Shot input : [SHOT INPUT]
Set the shot number for Shot distance measurement.
●The valid range of values for the shot number is from 1 to 99.
●This setting is enabled only when the shot number
(Above 2.) has been set to “4.INPUT”.
4. Selection of Laser plummet : [LD PLUM.]
Laser plumb ON/OFF is selected.
5. Selection of Tilting angle display : [TILT DISP.]
X and Y tilting values are displayed.
6. Selection for Minimum tilt display : [TILT DISP. UNIT]
COARSE or FINE:
7. Selection of Reflectorless range : [RANGE]
If you need the Normal or Long range.
8. Selection of Long range message : [MESSAGE]
If you need the long range message.
9. Selection of Long range setup : [SET UP]
If the above No.7 selection is required each time or
permanent.
PENTAX R-300 (p53-64) 10/30/02 11:13 AM Page 57