29
[Auto focus:Target sighting by Continuous mode]
Loosen the telescope clamp and horizontal clamp screws.
Point the telescope at the target using a collimator.
Tighten the above two screws.
Adjust the eyepiece.
Look through the telescope and then press the AF button for two seconds to beep,
and release the key to enter into the Continuous mode.
Align the reticle accurately on the target using telescope and horizontal tangent
screws.
Point the telescope to the next target as well.
• Keep the target close to the reticle center when following it by the Continuous mode.
• Continuous mode automatically ceases after approx.one minute.
• Pressing the AF button or operating the Power focus key releases the continuous
mode.
• Operating the Power focus key rotates the AF ring,so do not touch it while it is rotating.
[Auto focus:Target sighting by Power focus mode]
Loosen the telescope clamp and horizontal clamp screws.
Point the telescope at the target using a collimator.
Tighten the above two screws.
Adjust the eyepiece.
Look through the telescope,and then operate the Power focus key and focus on the
target.
Align the reticle accurately on the target using telescope and horizontal tangent screws.
6
5
4
3
2
1
7
6
5
4
3
2
1
Collimator Target
AF button
Pressing AF
buttons for
two seconds
beeps and
release the
key.
Collimator
Target sighting