Perfectone Net Ware GW-200 manual Usage of the phone Receiving calls

GW-200 User Manual

X-0: Connect to FTP Server to get the file of updating program and save it to the SDRAM of the gateway. Then the file can be read by PalmTool. This operation aims at testing.

X-1: Connect to FTP Server to get the file of updating program and update program Flash. This operation aims at updating program.

X-2: Connect to FTP Server to get the file of updating dial rules and update program Flash. This operation aims at updating dial rule.

Note When you use ftp 0 and ftp 1 commands, if the file get from FTP server is too large or the net speed is too slow, then the process will not be seen in telnet window. Please be patient. Using ftp command in telnet to get file spends almost same minutes as getting file using gateway. So if nothing is displayed after too long time, it means that ftp is fail.

Note All the Telnet commands of GW-200 gateway should be written in low case and the password is case sensitive.

￿￿Usage of the phone

￿￿Receiving calls:

GW-200 gateway can receive incoming calls from other IP Phone or

another IP Gateway which and support the protocol. It works just like an

ordinary phone. When it rings, pick up the handset to answer the incoming

calls and finish, put the handset back.

￿￿Place a call

￿Call another IP Gateway or IP phone under the same Gatekeeper:

Pick up the handset and listen for the Internet dial tone. Then dial the phone number you wish to call and press [#] to end the dialing. Once the call connection has been established and the ring tone has sounded, wait

38