Adjustment
13 Adjustment
Please observe all notes from Chapter 1 Safety of the instruction manual! In particular care must be taken to see that all protective devices are refitted properly after adjustment, see Chapter 1.06 Danger warnings of the instruction manual!
Unless stated otherwise, during all adjustment work the machine must be disconnected from the electric and pneumatic power supply!
Danger of injury if the machine is started accidentally!
For the adjustments in this chapter the PFAFF 1296
13.01Notes on adjustment
All following adjustments are based on a fully assembled machine and may only be carried out by expert staff trained for this purpose.
Machine covers, which have to be removed and replaced to carry out checks and adjustments, are not mentioned in the text.
The order of the following chapters corresponds to the most logical work sequence for machines which have to be completely adjusted. If only specific individual work steps are carried out, both the preceding and following chapters must be observed.
Screws, nuts indicated in brackets ( ) are fastenings for machine parts, which must be loosened before adjustment and tightened again afterwards.
13.02Tools, gauges and other equipment
●Screwdrivers withi blade widths from 2 to 10 mm
●Spanners (wrenches) in sizes from 7 to 13 mm
●Allen keys from 1.5 to 6 mm
●Metal rule (part No.
●
●Gauge, (top feed stroke 7 mm) (Part No.
●Screw clamp (part No.
13.03Abbreviations
t.d.c. = top dead centre b.d.c. = bottom dead centre
13.04Explanation of the symbols
In this adjustment manual, symbols emphasize operations to be carried out or important information. The symbols used have the following meaning:
Note, information
Service, repair, adjustment, maintenance (work to be carried out by qualified staff only)
13 - 1