Disconnect a USB storage device
Caution
•Follow this procedure to avoid damage to your USB storage device.
1 Wait for five seconds before you disconnect the USB storage device.
Change TV preferences
Use the preferences menu to customise your TV settings.
1Press 
MENU.
2 Press 
to select [Installation] >
[Preferences].
•[Volume bar]: Displays the volume bar when you adjust the volume.
•[EasyLink]: Enables
3 Press | to select your preference. |
4Press OK.
5Press 
MENU to exit.
Access decoder channel
You can map channels provided through a decoder or descrambler to yourTV channel selection. In this way, you can select these channels by using the RC of yourTV.The decoder or a descrambler must be connected to EXT 1 (SCART).
Set decoder channel
Map channels from a decoder or descrambler.
1Press 
MENU.
2 Press | to select [Installation] > |
[Decoder]. |
|
3Press 
to enter [Decoder] menu.
4Press 
to select [Channel], then press
to enter.
5Select one channel to map to the decoder / descrambler channel and press OK to confirm.
6Select [Status], then press 
to enter.
7Select [EXT 1] (SCART), the connector used by the decoder / descrambler.
8Press OK.
9Press 
MENU to exit.
Note
•Select [None] if you do not want to map to the decoder / descrambler channel.
Reset the TV to factory settings
You can restore the default picture and sound settings of yourTV.The channel installation settings remain the same.
1Press 
MENU.
2 Press 
to select [Installation] >
[Factory settings].
3Press 
to enter [Factory settings].
4Select [Reset] to start resetting.
5Press OK.
6Press 
MENU to exit.
20EN
