FIRST TIME YOU TURN ON THE TV
he first time you turn on the new TV set, you will see a screen that helps you to auto install the programs. Auto Tinstallation starts with the analogue channels followed by the digital channels. The time taken for installation
depends on the number of channels available. You can stop the first auto installation by pressing the POWER button on the remote control. The auto installation is stopped and the TV goes into standby mode. Any channels that have already been found are stored.
Note :This screen will only appear the first time you turn on the TV. If you wish to auto install programs later, please follow the procedure on the next page (page 9).
| VIRGIN MODE |
|
| |
| Please connect Antenna or |
|
| |
| Cable to TV. |
|
|
|
| Select TV signal by or |
|
| |
| arrow key and press ok |
|
| |
| Signal Type | Antenna |
|
|
| Press OK to launch the Auto |
|
| |
| Channel Search. |
|
| |
| AUTO CHANNEL SEARCH |
| OK | |
| Go Back |
|
|
|
| Signal Type | Antenna |
|
|
| Start | Running |
|
|
| Analog Channel | 69 |
|
|
| Search percent | 83 |
|
|
| Digital Channel | 4 |
|
|
Installation may take about 30 min.
Follow the instructions on this screen to start auto installation:
Press CURSOR 
or 
to select Antenna or Cable.
Press OK button to confirm and start auto installation.
HELPFUL HINTS
ANTENNA : If you have an
CABLE : If you have subscribed to cable signal from any cable company, or you are receiving
The
8
