Philips 9160XL manual After Each Use Trimmer

22ENGLISH

C 4	Remove and clean one set of cutters and
	combs at a time.
C 5	Separate the cutter from the comb and
	rinse clean under hot water.
Do not clean more than one cutter and comb at
a time, since they are all matching sets. If you
accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
performance is restored.
C 6	Replace the set back into the Razor Head
	Assembly so that the ‘wings’ on the comb
	fit within the brackets located towards the
	center of the Assembly.
The set will only fit into the Razor Head Assembly
if the ‘wings’ are between the brackets. Make sure
that the two pointy edges of the head fit exactly
into the recesses.
7	Repeat the process for the other two sets
	of cutters and combs.
8	Replace the frame.
C 9	Press down (1) and turn wheel clockwise
	(2) until it locks into place.
10	Close the Razor Head Assembly.

ENGLISH 23

Once A Month: Razor Heads

For optimum performance, razor cutters and combs should be cleaned in a degreasing liquid (e.g. Philips Norelco Razor Cleaner, model RC1776, or rubbing alcohol) and lubricated with Philips Norelco Razor Lubricant, model AL80, or one drop of mineral oil (in the center of the head). This helps prevent wear of the shaving heads.

After Each Use: Trimmer

1	Turn razor OFF.
2	Push down spring-release trimmer switch.
C 3	Clean trimmer with the brush every time
	you use it.
C 4	Lubricate the trimmer teeth with Philips
	Norelco Razor Lubricant (model AL80) or
	with one drop of mineral oil every 6
	months.
5	Close trimmer by pressing trimmer down.

This razor has no other user-serviceable parts.

Any other service should be performed by the

Philips Norelco Service Location.