Philips CDR 760 Power supply, Set-up recommendations, Press ON/OFF to turn the CD recorder on

English

INSTALLATION

Power supply Inserting batteries in the remote control

1Plug the power cord supplied into the MAINS connector on the CD recorder, then into a wall socket.

2Press ON/OFF to turn the CD recorder on.

Note:

-The CD recorder will automatically adjust to the local mains voltage.

-When the CD recorder is in the “OFF” position, it is still consuming some power. If you wish to disconnect your CD recorder completely from the mains, withdraw the plug from the AC Outlet.

Set-up recommendations

-Place the CD recorder on a solid, vibration free surface.

-Do not place the CD recorder near a source of heat or in direct sunlight.

-Do not use the CD recorder under extremely damp conditions.

-If the CD recorder is placed in a cabinet, make sure that a one-inch space remains free on all sides of the recorder for proper ventilation.

1Open the battery compartment cover.

2Insert 2 batteries (AAA, R03 or UM-4; as supplied) as shown.

3Replace the cover.

Note: We recommend using 2 batteries of the same type and condition.

Batteries contain chemical substances; dispose of them properly.

10