Philips CF-30FTSAZAM service manual Setting the KB Cable Cover, Keyboard and LCD Cable Cover

7.2.16. Setting the KB Cable Cover, Keyboard and LCD Cable Cover

1.Set the Keyboard onto the Computer.

2.Connect the 2 Cables to the 2 Cables. (CN13,CN14)

3.Fix the KB Cable Cover using the 7 Screws. <N29> No1 to No7

4.Set the LCD Cable Plate.

5.Fix the LCD Cable Cover using the 3 Screws. <N29> No1 to No3

Note:

Tighten the Screws in the numbered order (No1 to No7). Tighten the Screws in the numbered order (No1 to No3).

Screws <N29>: DRQT26+E3FNL

		No.3	No.5
		<N29>	<N29>
	No.4	No.1	No.7
to Connector		<N29>	<N29>
	<N29>		No.2
(CN14)
			<N29>
	No.6		KB Cable Cover
			No.2
<N29>
			<N29>

to Connector	LCD
	Cable Cover
(CN13)
	No.3
	<N29>
	No.1
	<N29>

Keyboard	LCD
	Cable Plate

Connector

(CN14)

Connector

(CN13)

■Arranging the Keyboard

	* Notes:
	1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
	1. Attach the Keyboard US and Keyboard Spacer. (KB Preparation)
	2. Attach the Keyboard Back Plate and Keyboard Spacer Sheet. (Plate Preparation)
Keyboard US is installed	(Ensure Keyboard Spacer Sheet does not run over the level of Keyboard Back Plate.)
	3. Attach the prepared KB to the prepared plate.
	(Insert the KB protrusions into the plate holes and determine the position.)
	Plate hole

Attach the Keyboard

Spacer Tape

Attach the Keyboard

Back Plate

Attach the Keyboard

Spacer Sheet

Attach the Keyboard Fook Spacer Lower : Fit to the edge of plate (KBD back plate).

Both sides should not come over the plate.

7-32