Philips CF-30FTSAZAM service manual Preparation of Inverter, Assembly of LCD Unit

■Preparation of Inverter

* Notes:

1.Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2

2.When handling Inverter-PCB, do not bend or add impact.

	Check the Part No.
N0GF1J000009(without T.S.)	N0GF1J000009

S2 Inverter Shield Case

Prepare Inverter and the Inverter shield case outside for assysite.

N0GF2J000002

Check the Part No.

HBL-0361

Inverter Shield Case Outside

Wrap Inverter Shield Tape around Inverter Shield Case and attach.

Ensure that Inverter Shield Tape does not run over the edge of Inverter Shield Case.

	Inverter is set,	Inverter Shield Case is set
		Attach the Inverter Shield Tape
	attach
Board attachment

<Inverter Shield Tapes Attachment Guide> Protorusion by wrinkles, etc. = 0.2 or less Air Bubble = 1 cm 2 or less / 1 bubble size

Attach it putting the protrusion mark next to the caution label.

Match the board edge and the case edge.

Difference: 0.5mm or less

■Assembly of LCD Unit

* Notes:

1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2

Confirm that the LCD

Cushion is not wrapped.

Attach the Inverter MIL Shierd

Match to the LCD edge and attach it.

Clearance : 2 mm or less

0 0.5mm

LCD Drop Holder Insertion

LCD Front Ass'y

LCD Drop Holder Insertion

7-14