Philips DVD750VR/17 owner manual First-time DVD/VCR Setup, Turn on the TV

H9420UD(p1-51).QX4 03.7.18 11:59 AM Page 17

First-time DVD/VCR Setup 17

Before turning on your DVD/VCR, make sure batteries are in the remote control and the DVD/VCR and TV are connected correctly. You cannot program channels if you are using a Cable Box or a Satellite Receiver.

These menus may not appear if you have already turned on the DVD/VCR.

1 Turn on the TV. Set it to channel 3 or 4 or its AUDIO/VIDEO IN channel, depending on how you con- nected the DVD/VCR to a TV.

2 Press VCR, then press STANDBY-ON. The green VCR light will appear on the front of the DVD/VCR.The display shown below will appear.

These menus may not appear if you have already turned on the DVD/VCR.You may have turned on the DVD/VCR before to find the Audio/Video In channel of the TV, for example. If so, follow the steps on page 26 to set up chan- nels and page 30 to select a language for the VCR menus.

3 Press o or p to select English, French, or Spanish as the language for VCR on-screen displays and menus. Then, press B.

1 Turn on the TV.

		STANDBY-ON		2
SEARCH	MODE	DISPLAY
REPEAT	REPEAT	AUDIO
	A-B
SUBTITLE	ZOOM	ANGLE	SKIP / CH
RETURN	TITLE CLEAR/RESET		SLOW
	VCR/TV
DVD			VCR
SYSTEM		DISC/VCR
MENU		MENU

OK 3-4

STOP PLAY PAUSE

TIMER SET VCR Plus+ RECORD

SPEED

1 2 3

4 5 6 7

8 9 0 +10

AUTO SET UP

4 Press B to begin channel programming. AUTO SETUP will flash on the TV screen during the channel search.The DVD/VCR will memorize all available channels. When channel programming is complete, the lowest avail- able channel will appear on the TV.

These channels will be available when you want to watch TV while in VCR mode.To put the DVD/VCR in VCR mode, press VCR so the green VCR light appears. Use the SKIP3/CHo and SKIP /CHp buttons to select memo- rized channels.To select non-memorized channels, use the Number buttons.

Helpful Hints

•To skip this feature and play a tape immediately, insert a tape with its record tab removed.

•To skip step 3, press DISC/VCR/MENU.VCR menus and displays will be in English.

•If you try to program channels when there is no antenna or Cable TV signal connected to the ANT-IN jack of the DVD/VCR, programming will stop. AUTO SET UP will stop flashing. Connect an antenna or Cable TV signal to the DVD/VCR’s ANT-IN jack and press B again.

•Repeat this process if the power fails.

•To stop the Channel Setup while AUTO SET UP is flashing, press DISC/VCR/MENU.