Getting Started
Step 1: Inserting batteries into the Remote Control
1Open the battery compartment.
2Insert two batteries type R03 or AAA, following the indications
3Close the cover.
Using the Remote Control to operate the Player
1Aim the Remote Control
directly at the remote sensor (IR) on the front panel.
2Do not put any objects between the Remote
Control and the DVD Player while operating the DVD Player.
CAUTION!
–Remove batteries if they are exhausted or if the Remote Control is not being used for a long time.
–Do not use old and new or different types of batteries in combination.
–Batteries contain chemical substances, so they should be disposed properly.
Step 2: Setting up the TV
IMPORTANT!
Make sure you have completed all the necessary connections. (See pages
1Turn on the TV and set to the correct
2Usually these channels are between the lowest and highest channels and may be called FRONT,A/V IN, or VIDEO. See your TV manual for more details.
➜Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In channel.
➜Or, the TV Remote Control may have a button or switch that chooses different video modes.
➜Or, set the TV to channel 3 or 4 if you are using an RF modulator.
3If you are using external equipment, (eg. audio system or receiver), turn it on and select the appropriate input source for the DVD player output. Refer to the equipment owner’s manual for detail.
E n g l i s h
17
17 | 13/02/06, 2:40 PM |
