Philips e9000 manual Battery-low indicator, Multiple-LED charge indicator, Using the appliance

English

1Make sure the bottom of the handle sits back securely in the charger so that it makes complete contact.

-The handles of other Sonicare models do not fit in this charger and will therefore not charge effectively. Do not attempt to force a handle into this charger, as this causes damage.

Battery-low indicator

,When the battery runs low, you hear 3 beeps after the Smartimer

has switched off the toothbrush. In addition, the bottom LED flashes yellow for 30 seconds.

When you see and hear the battery-low indication, 3 or fewer 2-minute brushings remain.

Keep the Sonicare in the plugged-in charger when not in use to maintain a full battery charge.

Multiple-LED charge indicator

,When you place the handle in the charger, the green charge indicator LEDs flash in a rising pattern as the battery charges.The number

of flashing LEDs indicates the level to which the battery has been

charged.

When the battery is fully charged, the LEDs stop flashing and start burning

continuously. About once a minute, the charge indicator LEDs go out

briefly and then go on again.This indicates that the battery is maintained

at full charge.The full-charge indication persists until you remove the handle from the charger.

Using the appliance

Useful tips

-The brush head comes with a convenient travel cap. Remove the travel cap from the brush head before you switch on the Sonicare.

-Rinse the brush head and bristles after each use.

-Clean the brush head weekly, including under the nut.

-A fully charged Sonicare allows you to brush your teeth for 2 minutes twice a day for approximately 2 weeks without charging.This makes it easy to travel without the charger.

-Voltage converters and plug adapters DO NOT guarantee voltage compatibility. Always check for voltage compatibility.