Philips FW-D550 manual Connecting TV set, Using Video In jack CVBS, You only need to make onevideo

Connections
Step 3: Connecting TV set				English
Television
P		D	(	D
D	U	U (		U
(CVBS)
LINE
OUT
AUX/
TV
IN

IMPORTANT!

–You only need to make one video

connection from the following options, according to the capabilities of your TV system.

–S-Video or Component Video

connection provides higher picture quality.These options must be available on your TV set.

–Connect the system directly to the TV set.

Using Video In jack (CVBS)

●Use the composite video cable (yellow) to connect the system’s CVBS jack to the video input jack (or labeled as A/V In,Video In, Composite or Baseband) on the TV set.

●To listen to TV channels through this system, use the audio cables (white/red) to connect AUX/ TV IN (L/R) jacks to the corresponding AUDIO OUT jacks on the TV set.

IMPORTANT!

–If both S-Video and Component (Pr Pb Y) Video connections are used to connect to your TV set, the Video signal will automatically switch to S-Video when you power up the system.To set the VIDEO OUT (put) to ‘Pr Pb Y’, see page 31, Using the Setup Menu – Setting the video out.

Using component Video In jack (Pr Pb Y)

●Use the component video cables (red/blue/ green) to connect the system’s Pr Pb Y jacks to the corresponding Component video input jacks (or labeled as Pr/Cr Pb/Cb Y or YUV) on the TV set.

●To listen to TV channels through this system, use the audio cables (white/red) to connect AUX/ TV IN (L/R) jacks to the corresponding AUDIO OUT jacks on the TV set.

11