Philips FW-D550 Preparations, Using the remote control to operate the system, Setting the clock

Preparations

IMPORTANT!

–Make sure to complete the preparation procedures before operating the system.

Step 1: Inserting batteries into the remote control

3

1

2

1Open the battery compartment.

2Place two batteries (Type R06 or AA) in the compartment with the correct polarity as indicated by “+” and “–” symbols.

3Close the cover.

Using the remote control to operate the system

1 Point the remote control directly at the remote sensor (iR) on the front panel.

2 Select the source you wish to control by pressing one of the source select buttons on the remote control (for example TAPE,TUNER).

3Then select the desired function (for example 2;, 4, ¢).

CAUTION!

–Remove batteries if they are exhausted or will not be used for a long time.

–Do not use old and new or different types of batteries in combination.

–Batteries contain chemical substances, so they should be disposed of properly.

Step 2: Setting the clock

The clock can be set in either 12-hour or 24- hour mode (“PM 00:00” or “00:00” for example).

1Go into Standby mode.

➜If you have not set the clock, “--:--” will blink until you set the clock.

2Press CLOCK and “00:00” blinks on the display.

➜The current time is flashing on the display.

➜If you have not set the clock, “--:--” will appear on the display.

3Press O or P on the system to set the hours.

4Press 5 or 6 on the system to set the minutes.

5Press CLOCK to confirm your setting, and then go into standby mode.The system will store the setting automatically.

➜The time setting becomes effective.

To exit the setting without storing

●Press 9 on the system to exit.

➜“CANCEL” will appear on the display.

●Press ECO POWER to exit setting mode and go into ECO POWER mode.

●You can also press DISC, DISC1~3, DISC CHANGE, OPEN/CLOSE to exit setting mode and go into disc mode.

●The system will also exit setting mode and go to tuner, AUX, tape mode wheh you press the corresponding source button.

Viewing the clock

●In Standby mode, press DISPLAY on the system to toggle between 12-hour and 24-hour modes.

➜The time will be displayed.

Notes:

–The clock will be cancelled when the power cord is disconnected or if a power failure occurs.

–During clock setting, if no button is pressed within 30 seconds, the system will exit the setting mode and go into standby mode.

English

19