Philips HD8747, HD8743, HD8745 English, The machine is performing the rinse/self- cleaning cycle

38 ENGLISH

Light Signals		Causes	Solutions
		The coffee bean hopper is empty.	Fill the coffee bean hopper with coffee beans and start the
			procedure again.
		The coffee grounds drawer is full.	With the machine turned on, empty the coffee grounds drawer. If
			the coffee grounds drawer is emptied with the machine turned off
			the coffee cycle counter is not reset. Wait until the “ ” light starts to
	Steady on		flash before placing back the coffee grounds drawer.
		The water circuit is empty.	Fill the water tank with fresh water and dispense hot water as
			described in Section “Using the Machine for the First Time”.

Quickly flashing

Brew group is not inserted. Coffee ground drawer is not inserted.

Service door is open.

Control dial is not in correct position.

Make sure that all components have been correctly inserted and closed. The flashing “” light will now turn off.

Slowly flashing

The machine is performing the rinse/self- cleaning cycle.

The machine ends the rinse/self-cleaning cycle automatically. You can interrupt the rinse/self-cleaning cycle by pressing “”

either “” buttons

Flashing in counter-clockwise

direction

A fault has occurred in the brew group. Try again to brew another espresso or a coffee.

Flashing alternately

The machine is out of order.

Turn the machine off. After 30-seconds, turn it back on. Try this 2 or 3 times.

If the machine does NOT start, contact the Philips Saeco hotline.

Flashing simultaneously