Philips HTS3300 Troubleshooting continued, Problem, Solution, The DVD system does not, work

		Troubleshooting (continued)
Problem		Solution
The DVD system does not	–	Insert a readable disc with the playback side facing down. The
start playback.		DVD+R/CD-R must be finalised.
	– Check the disc type, colour system (PAL or NTSC) and region
		code.
	– Check for any scratches or smudges on the disc.
	– Press SETUP to turn off the setup menu screen.
	– You may need to enter the password in order to change the
		parental control rating level or to unlock the disc for playback.
	– Moisture may have condensed inside the system. Remove the
		disc and leave the system turned on for about an hour.
There is no sound from the	–	Make sure the centre and surround speakers are connected
centre and surround speakers.		correctly.
	– Press SURR button to select a correct surround sound setting.
	– Make sure the source you are playing is recorded or broadcast
		in surround sound (DTS, Dolby Digital, etc.).
Radio reception is poor.	–	If the signal is too weak, adjust the antenna or connect an
		external antenna for better reception.
	–	Increase the distance between the system and your TV or VCR.
	– Tune in to the correct frequency.
	– Place the antenna further away from any equipment that may be
		causing the interference.
The remote control does not	–	Select the source (DISC or TUNER, for example) before
function properly.		pressing the function button (É, S, T).
	– Reduce the distance between the remote control and the
		system.
	– Replace the batteries with new ones.
	– Point the remote control directly toward the IR sensor.
	– Check that the batteries are loaded correctly.
Unable to play DivX movies.	–	Check that the DivX file is encoded in ‘Home Theatre’ mode
		with DivX 5.x encoder.
The DVD system does not	–	Disconnect the power cord from the power outlet for a few
work.		minutes. Reconnect the power cord and try to operate again as
		usual.

Need Help? Visit us at www.philips.com/support

43

E n g l i s h

3139 115 2xxx1