Troubleshooting continued, Problem, Solution, English

Troubleshooting (continued)

Problem	Solution

English

Unable to select some items in the setup/system menu.

–Press ÇSTOP button twice before selecting the system setup menu.

–Depending on the disc availability, some menu items cannot be selected.

–Insert a readable disc with the playback side facing down. The DVD+R/CD-R must be fi nalised.

–Check the disc type, colour system (PAL or NTSC) and region code.

–Check for any scratches or smudges on the disc.

–Press SYSTEM MENU to switch off the system setup menu screen.

–You may need to enter the password in order to change the parental control rating level or to unlock the disc for playback.

–Moisture may have condensed inside the system. Remove the disc and leave the system switched on for about an hour.

–Press the SURR. button to select a correct surround sound setting.

–Make sure the source you are playing is recorded or broadcast in surround sound (DTS, Dolby Digital, etc.).

–If the signal is too weak, adjust the antenna or connect an external antenna for better reception.

–Increase the distance between the system and your TV or VCR.

–Tune in to the correct frequency.

–Place the antenna further away from any equipment that may be causing the interference.

–Select the source (for example, SOURCE) before you press the function button (É, . , >).

–Reduce the distance between the remote control and the DVD system.

–Replace the batteries with new ones.

–Point the remote control directly toward the IR sensor.

–Check that the batteries are loaded correctly.

–Check that the DivX fi le is encoded in ‘Home Theatre’ mode with DivX 5.x/6.x encoder.

–Disconnect the power cord from the power outlet for a few minutes. Reconnect the power cord and try to operate again as usual.

–Press and hold the ÇSTOP button on the remote control, followed by pressing number button “2”, “5” and “9”.