Philips LX7000SA Radio Reception, Automatic preset from a desired preset number, g l i s h

E n

Radio Reception

Plug and Play Tuning to radio stations

g l i s h

Plug and Play allows you to store all available radio stations automatically.

First time setup/power up

1When you turn on the power, "AUTO INSTALL - PRESS PLAY" is displayed.

2PressÉÅ on the system to start installation.

➜"INSTALL TUNER" is displayed, followed by "AUTO PROGRAM".

➜The system will automatically store the radio stations with sufficient signal strength, starting with FM band and followed by AM band. Weak radio stations may be stored in later presets.

➜When all the available radio stations are stored or the memory for 40 presets is used, the last preset radio station will be played.

To reinstall the Plug and Play

1In standby mode, hold downÉÅon the system until "AUTO INSTALL - PRESS PLAY" is displayed.

2PressÉÅagain to start installation.

➜ All previously stored radio stations will be replaced.

To exit the Plug and Play

●Press Ç on the system.

➜ If you do not complete the Plug and Play installation, the function will be restarted when you turn on the power again.

Notes:

–If no stereo frequency is detected during Plug and Play, "CHECK ANTENNA" will be displayed.

–During Plug and Play, if no button is pressed within 15 seconds, the system will exit Plug and Play mode.

1Press SOURCE to select TUNER mode (or TUNER on the remote control.

2Press TUNER again to select the desired band : FM or AM.

3Hold down S or T until the frequency indication starts to change, then release.

➜ The system automatically tunes to the next strong signal radio reception.

●To tune to a weak station, press S or T briefly and repeatedly until an optimal reception is found.

4Repeat step 3 if necessary until you find the desired radio station.

Presetting radio stations

You can preset up to 40 radio stations in the memory.

Automatic preset from a desired preset number

1In tuner mode, press 1 or 2 or use the numeric keypad (0-9)to select the desired preset number.

2Hold down PROG until “AUTO PROGRAM” is displayed.

➜If a radio station has been stored in one of the presets, it will not be stored again under another preset number.

➜If no preset number is selected, automatic preset will begin from preset (1) and all your former presets will be overridden.

To exit the preset setting

●Press PROG or Ç on the system.

Manual preset of favorite radio stations

1Tune to your desired radio station (refer to “Tuning to radio stations”).

2Press PROG twice.

➜ The preset number starts flashing.

3Press 1 or 2 or use the numeric keypad (0-9)on the remote control to select the desired preset number.

4Press PROG again to store the radio station.

●Repeat steps 1–4to store other radio stations.

5To exit, press Ç. Notes:

–If you attempt to program more than 40 preset radio stations, "PROGRAM FULL" is displayed.

–During programming, if no key is pressed within 15 seconds, the system will exit the program mode automatically.

26RADIO RECEPTION