Philips MCD290 Connecting speakers, Antenna connection, Connecting TV, Using Video In jack Cvbs

	Connections
Step 2: Connecting speakers	FMAntenna
	It is unnecessary to connect the FM pigtail
	antenna since it is fixed to the main unit.
	● Adjust the FM antenna for optimal FM stereo
	reception.

English

Connect the speaker wires to the SPEAKERS terminals, right speaker to "RIGHT" and left speaker to "LEFT", coloured (marked) wire to "+" and black (unmarked) wire to "-". Fully insert the stripped portion of the speaker wire into the terminal as shown.

Notes:

–Ensure that the speaker cables are correctly connected. Improper connections may damage the system due to short-circuit.

–For optimal sound performance, use the supplied speakers.

–Do not connect more than one speaker to any one pair of +/- speaker terminals.

–Do not connect speakers with an impedance lower than the speakers supplied. Please refer to the SPECIFICATIONS section of this manual.

Step 3: Antenna connection

MW Antenna

Connect the supplied MW loop antenna to the "MW AERIAL" terminal. Adjust the position of the antenna for optimal reception.

●Position the antenna as far as possible from a TV, VCR or other radiation source.

Step 4: Connecting TV

IMPORTANT!

–You only need to make one video

connection from the following options, depending on the capabilities of your TV system.

–Connect the DVD system directly to the TV.

Using Video In jack (CVBS)

1Use the composite video cable (yellow) to connect the system's VIDEO jack to the video input jack (or labelled as A/V In,Video In, Composite or Baseband) on the TV set.

2To hear the sound of this DVD Player through your TV, use the audio cables (white/red-not supplied) to connect LINE OUT (L/R) jacks of the DVD Player to the corresponding AUDIO IN jacks on the TV.

11