1 General Safety Information
Do not make any changes or settings that are not described in this user manual. Physical injury or damage to the device or loss of data can result from improper handling. Take note of all warning and safety notes indi- cated.
Under the following conditions, a layer of moisture can appear inside the device which can lead to malfunctions:
·if the device is moved from a cold to a warm area;
·after a cold room is heated;
·when this device is placed in a damp room.
Proceed as follows to avoid any moisture
Setting Up the Device
The device is exclusively for indoor use. The device should be placed securely on a stable, flat surface. Posi- tion all cables in such a way that no one will stumble on them, thus avoiding possible injuries to persons or dam- age to the device itself.
Do not plug in the device in moist rooms. Never touch the mains cable or the mains connection with wet hands.
The device must have sufficient ventilation and may not be covered. Do not put your device in closed cabinets or boxes.
Do not place the machine on soft surfaces such as table- cloths or carpets and do not cover the ventilation slits. Otherwise the device could overheat or catch fire.
Protect the device against direct sunlight, heat, large temperature fluctuations and moisture. Do not place the device in the vicinity of heaters or air conditioners. Observe the information on temperature and humidity in the technical data.
When the device is running for a long period of time, the surface becomes hot and a warning symbol appears on the projection. The device switches automatically to
Do not allow liquids to enter into the device. Switch off the device and disconnect it from the mains supply if liq- uids or foreign substances end up inside the device. Have the unit inspected by a technical service depart- ment.
Always handle the unit with care. Avoid touching the lens. Never place heavy or sharp objects on the projec- tor or the power cable.
If the projector gets too hot or emits smoke, shut it down immediately and unplug the power cable. Have your device examined by trained professionals at a tech- nical service location. To prevent the spread of fire, open flames should be kept away from the device.
1Seal this device in a plastic bag before moving it to another room, in order for it to adapt to room con- ditions.
2Wait one to two hours before you take the device out of the plastic bag.
The device should not be used in a very dusty environ- ment. Dust particles and other foreign objects may damage the unit.
Do not expose the device to extreme vibrations. It may damage the internal components.
Do not allow children to handle the device without supervision. The packing materials should be kept out of the hands of children.
Repairs
Do not make any repairs to the device yourself. Improper maintenance can result in injuries or damage to the device. Only have your device repaired by an authorised service centre.
Do not remove the type label from your device; this would void the warranty.
Power Supply
Use only a compatible power adapter (see chapter Appen- dix / Technical Data). Check whether the mains voltage of the power supply matches the mains voltage available at the setup location. This equipment complies with the volt- age type specified on the unit.
The capacity of the battery diminishes with time. If the device functions only with the power supply, the battery is defective. Contact an authorised service centre to replace the battery.
Do not try to replace the battery yourself. Incorrect handling of the battery or using the wrong type of bat- tery can cause damage to the device or cause injury.
4 | Philips · PPX2230 · 2330 |
