Quick start

This unit will resume recording pause mode about 0.8 seconds after the LCD monitor is reopened.

Start time will not shorten if there is no SD card inserted.

SDR-H85

Start time will be shorten if the [HDD] is selected in the [MEDIA SELECT], even if there is no SD card inserted.

¬Change the mode to .

1 Select the menu. (l 23)

[SETUP] # [QUICK START] # [ON]

2 Close the LCD monitor while the mode is set to .

The status indicator A flashes green and the unit goes into quick start standby mode.

3 Open the LCD monitor.

The status indicator A lights red and the unit is put into recording pause.

When in quick start standby mode about 70% of the power used in recording pause mode is being consumed, so the recording time will be reduced.

Quick start standby mode is cancelled if jabout 5 minutes elapsed

jmode is set to

It may take some time for automatic white balance to adjust.

In the quick start mode, the zoom magnification becomes 1k.

If [ECONOMY] (l 25) is set to

[5 MINUTES] and the unit automatically goes into quick start standby mode, close the LCD monitor and then open it again.

Turn the unit off using the power button.

Quick power on

When the power is turned on with the mode

set to , the unit will enter the recording pause mode after about 1.9 seconds.

Select the menu. (l 23)

[SETUP] # [QUICK POWER ON] #

[ON]

In the quick power on mode, the zoom magnification becomes 1k.

35

VQT2L35

Page 35
Image 35
Philips SDR-S50 Quick start, Quick power on, Close the LCD monitor while the mode is set to, Open the LCD monitor