Configuring the Philips amBX PC Gaming Peripherals
The Stop button is a toggle button. When you press the button, an action starts and the label of the button changes, describing the opposite action.
Toggled State 1
Pressed
Toggled State 2
To resume the Philips amBX™ PC Gaming Peripherals and scenes,
•When Direct Control is not open, 
in the taskbar and select Resume from the pop up menu.
•When Direct Control is open, click the same button in the Configuration screen that is now labeled 'Resume'.
Note
When you click the 'Resume' button, only the devices that are enabled in the Configuration Screen will start working. You can enable the disabled devices in the Peripheral Settings panel.
Tip
If you will not be using the peripherals for a while, you can set the peripherals in Standby mode by pressing the On/Off button on the Wall Washer & Controller hardware or on the Speaker Lights. When the peripherals are in Standby, the LED indicator in the button is not lighted. You awake the peripherals by pressing the On/Off button again.
Placing the peripherals in standby will not have any effect on the representation of the peripherals in Philips amBX™PC Gaming Direct Control.
Reset Philips amBX™ PC Gaming Peripherals to their Defaults
1.Select the Configuration tab. The 'Configuration' screen appears.
2.Click the Reset to defaults button.
The Philips amBX™ PC Gaming Peripherals return to their defaults:
•the default position (as shown on the image below);
•the height 'None';
•100% intensity.
Default position of the Philips amBX™ PC Gaming Peripherals
21
