Kodak Digital Photo Frame manual Picture frame/computer communications

Troubleshooting and support

Resetting the clock after losing power

If you turn off the power on the frame or otherwise lose power for half a day or more, the clock time returns to the factory setting and the automatic on/off times, if set, are disabled.

■When you turn the frame back on, the set time screen appears on the frame.

■Slide to set the hour. Tap the left/right arrows to highlight the previous or next setting (hour and minutes), then slide to adjust the setting.

■Tap OK.

The Home screen appears. The time is reset and the automatic on/off times (if set) are re-enabled. It is not necessary to reset the on/off times.

NOTE: If you exit the set time screen without setting the time, you can manually reset the clock and re-enable the automatic on/off times (see page 58). It is not necessary to reset the on/off times.

Picture frame/computer communications

If...	Try one or more of the following
Cannot copy pictures to my	■ Make sure your frame and computer are on.
computer.	■ Make sure to install the software that was packaged with
Cannot see my frame as a	your frame (see page 8) and copy pictures between your
	frame and computer using the EASYSHARE Digital Display
removable drive.
	Software (page 44).
	■ Make sure the USB cable is securely connected (page 26).
	■ Make sure the power button on the frame is On (page ii).
Cannot copy pictures from	■ Make sure your frame and computer are on.
KODAK EASYSHARE	■ Make sure the USB cable is securely connected (page 26).
Software.	■ Make sure to install the software that was packaged with
	your frame (page 8).
	■ From My Collection in EASYSHARE Software, make sure the
	pictures are in the Picture Tray.

www.kodak.com/go/support 66