Speco Technologies DVR-16TS, DVR-4TN, DVR-8TN, DVR-16TN manual Dome Controlling Key, Set / Go Preset

User’s Manual

Users are allowed to change the RS-485 settings of the DVR-4TN/8TN/16TN/16TS/16TTseries unit. Select <System Setup> in the Main menu, then select <RS485 Setup> from the System Setup menu and press ENTER. The following menu is displayed.

		RS485 Setup
1	Unit ID	224
2	Baud Rate	9600
3	Bits	8
4	Stop	1
5	Parity	None

The ID number must match the ID address set by the dome. The Unit ID is within the range of 1 to 255. The default ID is 224. Note that no two devices on the same bus should be given the same ID address, or a conflict may occur.

The default DVR-4TN/DVR-8TN/DVR-16TNseries RS-485 settings are 9600 Baud, 8 Data Bits, 1 Stop Bit and No Parity.

NOTE: The settings become effective after saving the changes and exiting from the menu.

4.6.4Dome Controlling Key

The function keys used in Dome Control are illustrated below.

Set / Go Preset

This key is used to enter the Dome Preset menu to enable the set up of a specific position as a preset and to go to the predetermined preset positions for viewing.

46	DVR-4TN/8TN/16TN/16TS/16TT Series
	SPECO TECHNOLOGIES 01/06