Speco Technologies DVR-8TN, DVR-4TN manual Termination, Brightness, Contrast, Saturation, 10 Hue

User’s Manual

To set a camera to be covert, follow these steps:

•Select the channel that you want to be covert from the <Channel Select> item.

•After selecting the channel, move the cursor to <Covert> item and select <YES>.

5.3.6Termination

This item is used to enable / disable the 75-termination resistor inside the unit .that adjusts the image quality of each camera. <YES>= termination resistor enabled (default), <NO> = termination resistor disabled.

NOTE: If the camera loop-out connectors have not been used, the termination resistor should be enabled for appropriate signal termination.

5.3.7Brightness

Move the cursor to this item and press ENTER to adjust the brightness of the camera. Use UP / DOWN keys to adjust the numeric value. The range of brightness values is <-128> to <127>. The default setting is <0>.

5.3.8Contrast

Move the cursor to this item and press ENTER to adjust the contrast of the camera. Use UP / DOWN keys to adjust the value.

5.3.9Saturation

Move the cursor to this item and press ENTER to adjust the color saturation of the camera using UP / DOWN keys. This value will be ignored on monochrome monitors. The range of saturation values is <-128> to <127>. The default setting is <0>.

5.3.10Hue

Move the cursor to this item and press ENTER to adjust the hue of the camera. Use UP / DOWN keys to adjust the value.

80	DVR-4TN/8TN/16TN/16TS/16TT Series
	SPECO TECHNOLOGIES 01/06