Speco Technologies DVR-16TN, DVR-4TN, DVR-8TN manual Record Schedule / Quality Setting, Record Mode

User’s Manual

3.6Record Schedule / Quality Setting

The Record Setup menu allows the user to set recording quality, recording schedules and other recording parameters. This menu will not be able to access if you enter the OSD Setup Menu with User’s password. In the Main menu, move the cursor to <Record Setup> and press ENTER; the following menu is displayed.

	Record Setup
1. Record Mode		720×240@60PPS
2.	Schedule Setup
3.	Preset Config	Standard
4.	Per Camera Config
5. ezRecord Setup
6.	Data Lifetime	0 Days
7.	Pre-Alarm Recording	15 Sec
8.	Circular Recording	ON
9. Audio Recording		ON
10. Purge Data

3.6.1Record Mode

The Record Mode is for selecting resolution and recording rate. The relative record settings, such as preset configuration, will follow the record mode setting. In normal circumstance, we recommend you to select <720 × 240@60PPS> in NTSC format; or <720×288@50PPS> in PAL format.

Move the cursor to <Record Mode> and press ENTER, then select a Record mode using the UP / DOWN keys.

NOTE: After changing the Record Mode setting, this warning message “This will FORMAT ALL HARDDISKS and LOAD THE FACTORY DEFAULT CONFIG!” will appear on the screen. Press ENTER to confirm the selection. The unit will then start to format the hard disks and load the factory default settings, or press ESC to abort.

We strongly recommend that you back up your programmed configuration before making any changes to Record Mode settings.

DVR-4TN/8TN/16TN/ 16TS/16TT Series	27
SPECO TECHNOLOGIES 01/06