User’s Manual

2.1Position the Unit

Position / mount the DVR-4TN/8TN/16TN/16TS/16TTseries unit in an appropriate, steady location and make sure the power is off before making any connections. The area should avoid hindering or blocking the unit from airflow. Enough airflow is needed to protect the unit from overheating. The maximum allowable temperature of operating environment is 104°F/40°C.

The unit utilizes heat-conducting techniques to transfer internal heat to the case, especially to the bottom side of the unit.

NOTE: Be sure not to remove the rubber feet, and always leave a space for air ventilation on the unit’s bottom side.

2.2Selecting Video Format

The DVR-4TN/DVR-8TN/DVR-16TNseries unit is designed to operate under either NTSC or PAL video formats. Please contact a qualified service person to perform the installation procedure.

2.3Connecting Devices to the Unit

This section lists some important notices that should be read before making any connections to the DVR-4TN/8TN/16TN/16TS/16TT series unit.

NOTE: Connect short-term external devices, such as USB ThumbDrive®, USB CD-RW, USB Hard Disk Drive, etc., only after the unit is successfully powered up.

Connecting Required Devices

Before powering up, you should connect cameras and a main monitor to the unit for basic operation. If needed, connect a call monitor for displaying full screen video of all installed cameras in sequence.

DVR-4TN/8TN/16TN/ 16TS/16TT Series

13

SPECO TECHNOLOGIES 01/06

 

Page 14
Image 14
Speco Technologies DVR-16TT, DVR-4TN, DVR-8TN Position the Unit, Selecting Video Format, Connecting Devices to the Unit