SHC2000_booklet
Installation |
| Audio Connections | |
|
|
|
|
English
Headphone power supply
IMPORTANT
Only use R03/AAA NiMH batteries (preferably Philips).
1Check if the power button of the IR headphone is in the on position.
2Ensure the batteries are put in the battery compartment correctly according to the engraved polarity symbols.
3To recharge the headphone’s rechargeable R03/AAA NiMH batteries, first switch off the headphone.Then connect the charge cable between the headphone and the transmitter (figure 3).The recharging indicator will light up.
Note:
Completely flat batteries need approximately 16 hours to recharge.
Always remove the batteries if the headphone is not to be used for a long period of time.
Batteries contain chemical substances, so they should be disposed of properly.
Headphone battery replacement (figure 4)
IMPORTANT
Only use R03/AAA NiMH batteries (preferably Philips).
1Open the headphone’s battery compartment.
2Take out the batteries and dispose of them properly.
3Insert new batteries. Only use R03/AAA NiMH batteries (preferably Philips).
4Make sure the batteries are correctly inserted as indicated by the engraved symbols in the battery compartment.
5Close the battery compartment.
IMPORTANT
Before using the IR headphone for the first time, please ensure that the batteries are fully charged for about 16 hours.This will guarantee a longer operating lifetime of the batteries.
6