SHC2000_booklet
Controls |
| Installation | |
Transmitter (figure 1) | 12 Recharging input (figure 3) – connect | ||
the recharging cable to the transmitter. | |||
1 IR transmitting LEDs – transmit audio | |||
The recharging indicator on the headphone | |||
signal to IR headphone. | |||
must switch on, indicating that the | |||
| |||
2 DC power – connect to the 12 Volt/ | headphone is being recharged. | ||
200 mA AC/DC adapter. |
|
| |
English
3Power switch – power on/off switch.
43.5 mm stereo headphone audio input – connects your IR transmitter to an audio source.
5Recharging input – connect the recharge cable to the input.
6Controls plate Headphone (figure 2)
7IR sensors – to receive IR waves from the transmitter
8Power indication – lights up when in use.
9Power On/Off – slide the switch to the on or off position to switch the headphone on/off.
10Volume – adjust volume to your desired listening level.
11Recharging indicator – lights up when the recharging cable is connected between the headphone and the IR transmitter.
Completely flat batteries will be fully charged after about 16 hours.
Transmitter power supply
IMPORTANT
Use only Philips SBC CS030/00 12 Volt/200 mA AC/DC adapter. (For UK version: SBC CS030/05 12 Volt/200 mA AC/DC adapter)
1Make sure the adapter’s rated voltage corresponds to the mains socket voltage.
2Connect the DC connector of the AC/DC adapter to the 12 Volt DC power input connector located at the rear of the transmitter.
3Connect the 12 Volt/200 mA AC/DC adapter to the mains socket.
–Always disconnect the AC/DC adapter if the transmitter is not to be used for a long period of time.
Environmental Information
All redundant packing material has been omitted.We have done our best to make the packaging easily separable into two materials: cardboard and polyethylene
Your unit consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment.
5
