Philips SHC2000 manual Troubleshooting, Problem, Remedy, English, No sound, Distorted sound

SHC2000_booklet 12-01-2006 11:05 Pagina 8

English

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following these hints, consult your dealer or service centre.

WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the warranty.

Problem	Remedy
No sound	– Check if the AC/DC adapter is fully inserted into the
	AC outlet and that its DC connector is properly inserted
	into the 12 Volt DC input connector located at the rear
	of the transmitter.
	– Check if the headphone’s on/off switch is in the on
	position.
	– Headphone batteries running low. (See Headphone
	power supply)
	– Check if the audio source is switched on.
	– Volume not adjusted. Adjust the volume on the audio
	source/ headphone to a higher level.
	– Make use of the SHC2000 transmitter. Some
	transmitters already built into other equipment may not
	be compatible with the SHC2000 headphone because of
	the advanced technologies used in the SHC2000
	headphone.
Distorted sound	– Headphone batteries running low. (See Headphone
	power supply)
	– Check the volume on audio source/ headphone is not
	set at too high a level. Reduce the volume.
	– Distance from the transmitter is too large. Move closer
	to the transmitter.
	– Interference from fluorescent lamps/ other radio
	sources. Move transmitter or headphone elsewhere.
	– Make use of the SHC2000 transmitter. Some
	transmitters already built into other equipment may not
	be compatible with the SHC2000 headphone because of
	the advanced technologies used in the SHC2000
	headphone.

8