Philips SRM 5100 Instructions for use, Testing the remote control, Setting the remote control

SRM5100_Def 31-05-2007 16:43 Pagina 5

Instructions for use

Testing the remote control

The remote control has been programmed to operate all Windows Vista™ based PCs and most Philips devices (TV, STB and AMP).

Because the SRM 5100 may use different signals for each brand and even for different models of the same brand, it is advisable to test whether your device responds to the SRM 5100.

PC

There is no need to select PC mode first; the remote control is set to PC mode by default. Make sure your PC runs on Windows Vista™.

1Turn on your PC.

2Aim the remote control at the receiver and check if the PC reacts on

the remote control commands.

•If the PC does not respond to key commands, check that the batteries are properly inserted and the USB connector is properly plugged into the PC / laptop USB port. See ‘Setting the remote control’.

Other devices (TV, STB and AMP)

The example below (TV - TV, LCD TV, plasma TV, projector, HD TV) instructs you how to do this. You can repeat the same steps for other devices

(STB and AMP) which you want to operate using the SRM 5100.

Example of TV:

1Turn your TV on manually or use the original remote control. Tune to channel 1.

2Press the MODE key to select TV. Press the key until the TV LED lights up.

– The LED lights up for 10 seconds and then goes out.

• If the LED does not light up, check whether the batteries are properly inserted.

See ‘Setting the remote control’.

3 Check whether all keys are working. For an overview of the keys and their functions see ‘3. Keys and functions’.

– If the TV responds as it should to all of the key commands the SRM 5100 is ready TV.

•If the device does not respond at all or not to all of the key commands, follow the instructions under ‘Setting the remote control’, or for online setup go to: www.philips.com/urc

Setting the remote control

There is no need to set up the remote control for use with your Windows Vista™ based PC. For operating other devices set up is only necessary if the device (TV, STB and AMP) does not respond to the SRM 5100.

If that is the case, the SRM 5100 does not recognize the brand and / or model of your device and you need to program the remote control to do so. The example below (TV - TV, LCD TV, plasma TV, projector, HD TV) instructs you how to do this. You can repeat the same steps for other devices

(STB and AMP) which you want to operate using the SRM 5100.

English

5