Philips SRM 5100 user manual Manually setting the remote control

SRM5100_Def 31-05-2007 16:43 Pagina 7

Instructions for use

Manually setting the remote control

Example of TV (TV, LCD TV, plasma TV, projector, HD TV):

1Turn on the TV manually or use the original remote control. Tune in to channel 1.

2Look up the brand of your TV in the code list

at the back of this manual. One or more four- figure codes are shown for each brand. Note the first code.

Be careful! There are separate tables for TV, STB and AMP.

On our website www.philips.com/urc you can directly select your device typenumber to find the right code.

Make sure you use the codes from the correct table.

3Press the MODE key to select TV. Press the key until the TV LED lights up.

– The LED lights up for 10 seconds and then goes out.

4 Keep keys 1 and 3 pressed simultaneously for three seconds until the TV LED flashes twice and then remains lit.

5Then enter the code noted in step 2 using the digit keys.

–The TV LED key will now flash twice. If the LED flashes once for an extended period, the code has not been entered properly or the wrong

code has been entered. Start again from step 2.

6Point the SRM 5100 at the TV and check that it responds as it should.

– If the TV responds to all of the key commands, the SRM 5100 is ready for use. Do not forget to note your code.

•If the device does not respond at all, or not to all of the key commands, start again from step 2 and try the next code from the list.

English

7