VCR Display Panel | Philips VRA211AT instruction

VCR Display Panel 21

POWER VCR/TV

Cassette Compartment

Insert a tape here.

	PLAY
REW	F.FWD
CHANNEL	STOP/EJECT
CHANNEL	PAUSE

REC/OTR

PWR.(power) Light

This light appears when the power is on.

Cassette-Inside Light

This light appears when there is a tape in the VCR.

VCR Light

This light appears when the VCR is in VCR position. This light does not appear when the VCR is in TV position.

REC(ord) Light

This light appears during a record- ing. It flashes when a recording is paused.

Timer Light

This light glows when the VCR is turned off to set a timer recording or during a One- Touch Recording. It flashes if the power is off for a timer recording, but there is no tape in the VCR. It flashes when all timer recordings are finished.

Clock Display

The current time appears here when the clock is set. If the clock is not set, -:-- will appear here. PM will appear on the display, but AM will not.

Image 21

Philips VRA211AT owner manual VCR Display Panel

Contents

VRA211AT For Customer Use Dear Philips Magnavox product ownerThis bolt of lightning indi- cates uninsulated material Model No Serial No Features Safety PrecautionsIntroduction Table of Contents Using the Remote Control Putting Batteries in the Remote ControlVCR maintenance Removing the Plastic Cover from the Front Panel Disconnect the antenna or cable from your TV Hookups Without a Cable Box / Direct Broadcast System Plug in the TV and the VCR CH3 CH4 Connections Cable Signal RF coaxialRecording/Viewing Any Channel RF coaxial Cable TV’s ANTENNAJack Connect a Cable signal to the VCR’s ANTenna in Jack Cable SignalRecording One Channel/Watching Another Cable Box/DBS Hookups With a Stereo TV Turning on Your VCR Press the VCR button, then press the Power button2Turn on the TV Press the Menu button. The display shown below will appear Automatic Channel Setup Press the VCR buttonPress the Menu button Adding/Deleting Channels Automatic Channel Setup cont’d Reviewing Memorized Channels Press the VCR button Press the Menu buttonPress the STATUS/EXIT button once or twice to exit Enter a 0 before a single-digit number Setting the Clock Daylight-Savings Time Language Selection Remote Control Buttons Remote Control Buttons cont’d Status Display example only On-Screen Status DisplaysIf you select Status ON, then select Counter only on If you select Status ON, then select Counter only OFF VCR Display Panel Front Panel Rear Panel Playing Read and follow the steps below to play a tape1Turn on the TV 2Insert a tape in the VCR Insert a tape with its record tab intact in the VCR RecordingIf the VCR light appears on the display panel, go to . If VCR light does not appear, press the VCR/TV button once VCR light will disappear from the VCR’s display panel Recording One Channel/Watching Another One-Touch Recording Do each step within 60 seconds of the previous step Timer RecordingPress the VCR button, then press the Menu button Daily Timer Recording cont’d Timer Recording cont’d Press the STATUS/EXIT button. Program WAS COMTape Speeds Checking or Cancelling Timer Recordings Timer recording information for the program in the lowestProgram REVIEW, then press the F.FWD/B button RF coaxial cable Rerecording Tape Duplication Press the F.FWD/B button so that on appears beside Repeat Play Button to reset the real-time counter to zero Real-Time Counter MemoryWhile the status display is on-screen, press the Clear Forward and Reverse Searching SP/LP/SLP Special Effects PlaybackSuper High Speed Searching LP/SLP Viewing a Still Picture Automatic Operation Features Cable Box/DBS Output Channel 03 or Glossary Helpful Hints Helpful Hints cont’d Specifications Model # Serial # Limited Warranty Index Page Supplied Accessories